Jump to content

Recommended Posts

At almost 300USD for a pair for Monster Tech table mounts for HOTAS Cougar and Warthog Throttle and Stick I decided to make my own (with some variations in design) to save some money. Here is my project in a few pictures.

My parts after fabrication and before assembly.

TableMount[1].jpg

The assembled platform from several views.

TableMount[2].jpg

TableMount[3].jpg

TableMount[4].jpg

TableMount[5].jpg

And finally, attached for it's intended purpose.........

TableMount[6].jpg

Out

Edited by PoleCat
Link to post
Share on other sites

Great work! How do you keep the platform at the proper elevation? I didnt notice anything to tighten it, except to where it attaches to the desk itself.

Sliding inside corner brackets that tighten at whatever height along the vertical travel you like. Check the first photo. The longer piece of extrusion has the brackets slid loosely into place before attaching the shorter platform support piece. Photo 5 shows the inside corner brackets installed and tightened into place from below.

Two of these inside corners are more then enough to support the weight of the Cougar but I am using 4 of them just to be extra sure.

 

Link to post
Share on other sites
  • 4 weeks later...
  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.